With so many options, one carton cutter review just wasn’t enough, and I am now back to review one that has a higher price. But does that make it better quality?
The short answer is yes: it is better quality, but I’ll just go over a few things. The cutter has a bent and nicely shaped/joined sleeve made out of an unknown metal (probably steel), with an insert that is a folded piece of metal that will hold a razor blade. It also has a cutout “spring” that creates the tension instead of the body doing that, making it more pleasant to use. The sleeve also has a nice, easy-to-hold white paint applied, which makes it easier to see. The Master Mechanic logo that is printed on top of this looks nice but wears off easily and looks unsightly when it does.
Use is easy and smooth, tapping (a hard surface) both to deploy and retract the blade-holding mechanism (placing the back on a hard surface and pushing firmly will deploy the blade, and doing the reverse with the blunt part of the front will retract it), but it does have a way it “likes” to go in and works better that way. The razor blades that are included are also slightly better than the cheaper knife, but in general one won’t get much use out of single-edge razor blades, which are sharp but cheap and prone to snapping or deforming.
Is it worth it to buy a better version of such simple product? Probably not for most people. While this is a better carton cutter than cheaper ones, it isn’t really less dangerous or easier to use per-se. The fit and finish are as good as one could reasonably expect on a product this cheap; the amount of friction on deployment is constant; and the device will likely last for a long time. Still, a carton cutter isn’t a tool most people will be worrying about, and the less expensive ones would be easier to replace if they were misplaced or damaged.
Depending on the size or type of art (or craft) works one is doing, carton or box cutters may or many not be on one’s radar or considered a useful tool. But even if one isn’t using them for opening supplies or actually during the art-making process, it still isn’t a bad idea to have one around since they’re cheap and easy to use. The dozen-for-five-dollars that these are priced at might be a bit larger set than most people would need, but it’s still inexpensive enough that it wouldn’t be hard to pick up.
Tap knives are one of the simplest types of box cutter. On this model, the outside sleeve is a single aluminum piece that has been bent around on itself. Inside is another piece of aluminum that has been folded with a cutout at one end and a flare at the other. A standard single-edge razor blade fits in the cutout end (and can be replace by sliding the insert out of the housing) while the flare prevents the knife from protruding too far forward.
Use is simple. Tapping the back of the knife against a hard surface will extend the blade until it is stopped by the protrusion on the back. And when the cutting is done, the front of the knife can be tapped on a hard surface to retract the blade. Very little of the blade is exposed making it fairly safe to cut with, and it’s held in securely enough that I wouldn’t worry too much about accidental deployment of the blade. How well it cuts and how long it lasts depends on the razor blade used. And the ones that come in the package are not the greatest. The points are especially brittle, and while they can keep an edge for a decent amount of time, they will crack and split with too much stress.
As far as a cheap, effective, and simple box cutter goes, they work well enough. The fit and finish leave something to be desired: the edges are rough, the tolerances vary quite a bit, and no surface is smoothed and finished, but they are so inexpensive they are practically disposable. They cut, they’re reasonably safe, and they could last quite a long time since there’s not much too them. One could get better quality, but I’m not convinced you’d really need to.